Honed steel tube from China manufacturer is a high-precision steel tube material, which integrates the advantages of no oxide layer on the outer wall, no leakage under high pressure, high precision, high finish, no deformation after cold bending, flaring, flattening and no cracks. Mainly suitable for machining. What problems should we pay attention to when we disassemble the honed steel tube from China manufacturer?
1. Before disassembling the honed steel tube from China manufacturer, the hydraulic circuit should be depressurized. Otherwise, when the oil pipe joint connected to the oil cylinder is loosened, the high-pressure oil in the circuit will be sprayed out quickly. When the hydraulic circuit is depressurized, the handwheel or the pressure regulating screw of the relief valve should be loosened first to unload the pressure oil, and then the power supply or power source should be cut off to stop the operation of the hydraulic device.

2. The disassembly should be carried out in order. Due to the different structures and sizes of various honed steel tubes, the disassembly sequence is also slightly different. Generally, the oil in the two chambers of the cylinder should be drained, then the cylinder head should be removed, and finally the piston and piston rod should be removed. When disassembling the cylinder head of the honing tube, special tools should be used for the key or the snap ring of the internal key connection, and flat shovels are prohibited; the flange end cover must be pushed out with screws, and hammering or hard prying is not allowed . When the piston and piston rod are difficult to be pulled out, they cannot be forced out, and the reason should be found out before disassembly.
3. Before and after unloading, try to create conditions to prevent the parts of the honed steel tube from China manufacturer from being polluted by surrounding dust and impurities. For example, the disassembly should be done in a clean environment as much as possible; after disassembly, all parts should be covered with plastic cloth, not cotton cloth or other working cloth.